Documents

EC-D

Categories
Published
of 24
All materials on our website are shared by users. If you have any questions about copyright issues, please report us to resolve them. We are always happy to assist you.
Related Documents
Share
Description
gate previous year paper answer key
Transcript
  2013   Question Booklet Code EC-D 1/24 EC : ELECTRONICS AND COMMUNICATION ENGINEERING  Duration : Three Hours  Maximum Marks : 100 Read the following instructions carefully. 1.   Do not open the seal of the Question Booklet until you are asked to do so by the invigilator. 2.   Take out the O ptical R esponse S heet ( ORS) from this Question Booklet without breaking the seal and read the instructions printed on the ORS carefully. If you find that either: a.   The Question Booklet Code printed at the right hand top corner of this page does not match with the Question Booklet Code at the right hand top corner of the ORS or b.   The Question Paper Code preceding the Registration number on the ORS  is not EC , then exchange the booklet immediately with a new sealed Question Booklet. 3.   On the right hand side of the ORS,  using ONLY a black ink ballpoint pen , (i) darken the appropriate bubble under each digit of your registration number and (ii) write your registration number, your name and name of the examination centre and put your signature at the specified location. 4.   This Question Booklet contains 24  pages including blank pages for rough work. After you are permitted to open the seal, check all pages and report discrepancies, if any, to the invigilator. 5.   There are a total of 65 questions carrying 100 marks. All these questions are of objective type. Each question has only one  correct answer. Questions must be answered on the left hand side of the ORS  by darkening the appropriate bubble (marked A, B, C, D) using ONLY a black ink ballpoint pen  against the question number. For each question darken the bubble of the correct answer . More than one answer bubbled against a question will be treated as an incorrect response. 6.   Since bubbles darkened by the black ink ballpoint pen cannot  be erased, candidates should darken the bubbles in the ORS very carefully . 7.   Questions Q.1 – Q.25 carry 1 mark each. Questions Q.26 – Q.55 carry 2 marks each. The 2 marks questions include two pairs of common data questions and two pairs of linked answer questions. The answer to the second question of the linked answer questions depends on the answer to the first question of the pair. If the first question in the linked pair is wrongly answered or is not attempted, then the answer to the second question in the pair will not be evaluated. 8.   Questions Q.56 – Q.65 belong to General Aptitude (GA) section and carry a total of 15 marks. Questions Q.56 – Q.60 carry 1 mark each, and questions Q.61 – Q.65 carry 2 marks each. 9.   Questions not attempted will result in zero mark and wrong answers will result in NEGATIVE  marks. For all 1 mark questions, ⅓  mark will be deducted for each wrong answer. For all 2 marks questions, ⅔  mark will be deducted for each wrong answer. However, in the case of the linked answer question pair, there will be negative marks only for wrong answer to the first question and no negative marks for wrong answer to the second question. 10.   Calculator is allowed whereas charts, graph sheets or tables are NOT  allowed in the examination hall. 11.   Rough work can be done on the Question Booklet itself. Blank pages are provided at the end of the Question Booklet for rough work. 12.   Before the start of the examination, write your name and registration number in the space provided below using a black ink ballpoint pen. Name Registration Number EC D  2013   ELECTRONICS & COMMN. ENGG. - EC   EC-D 2/24 Q.1 to Q.25 carry one mark each. Q.1   Let 2 π t () gte − = , and () ht   is a filter matched to () gt  . If () gt   is applied as input to () ht  , then the Fourier transform of the output is (A) 2  f  e  π  −  (B) 2  /2  f  e  π  −  (C) || e  π  −  (D) 2 2 e  π  −  Q.2   The return loss of a device is found to be 20 dB. The voltage standing wave ratio (VSWR) and magnitude of reflection coefficient are respectively (A) 1.22 and 0.1 (B) 0.81 and 0.1 (C) − 1.22 and 0.1 (D) 2.44 and 0.2 Q.3   A source ()cos100 s vtVt  π  =  has an internal impedance of (4 +  j 3) Ω . If a purely resistive load connected to this source has to extract the maximum power out of the source, its value in Ω  should be (A) 3 (B) 4 (C) 5 (D) 7 Q.4   The transfer function )()( 12 sV sV  of the circuit shown below is (A) 115.0 ++ ss  (B) 263 ++ ss   (C) 12 ++ ss  (D) 21 ++ ss  Q.5   Assuming zero initial condition, the response )( t  y  of the system given below to a unit step input )( tu  is (A) )( t u  (B) )( t ut   (C) )( 2 2 t u t   (D) )( t ue t  −  Q.6   A polynomial 43243210 ()  fxaxaxaxaxa = + + + −  with all coefficients positive has (A) no real roots (B) no negative real root   (C) odd number of real roots (D) at least one positive and one negative real root  2013   ELECTRONICS & COMMN. ENGG. - EC   EC-D 3/24   Q.7   The minimum eigenvalue of the following matrix is 3525127275        (A) 0 (B) 1 (C) 2 (D) 3 Q.8   Which one of the following statements is NOT TRUE for a continuous time causal and stable LTI system? (A) All the poles of the system must lie on the left side of the  j ω  axis. (B) Zeros of the system can lie anywhere in the s-plane. (C) All the poles must lie within 1 s  = . (D) All the roots of the characteristic equation must be located on the left side of the   j ω  axis. Q.9   In a MOSFET operating in the saturation region, the channel length modulation effect causes (A) an increase in the gate-source capacitance (B) a decrease in the transconductance (C) a decrease in the unity-gain cutoff frequency (D) a decrease in the output resistance Q.10   A band-limited signal with a maximum frequency of 5 kHz is to be sampled. According to the sampling theorem, the sampling frequency which is not valid is (A) 5 kHz (B) 12 kHz (C) 15 kHz (D) 20 kHz Q.11   In a voltage-voltage feedback as shown below, which one of the following statements is TRUE if the gain k   is increased?   (A) The input impedance increases and output impedance decreases. (B) The input impedance increases and output impedance also increases. (C) The input impedance decreases and output impedance also decreases. (D) The input impedance decreases and output impedance increases.  2013   ELECTRONICS & COMMN. ENGG. - EC   EC-D 4/24 Q.12   For a periodic signal ,)4 / 500(63001010030)(  π  +++= t sint osct sint v  the fundamental frequency in rad/s is (A) 100 (B) 300 (C) 500 (D) 1500 Q.13   For 8085 microprocessor, the following program is executed. MVI A, 05H; MVI B, 05H; PTR: ADD B; DCR B; JNZ PTR; ADI 03H; HLT; At the end of program, accumulator contains (A) 17H (B) 20H (C) 23H (D) 05H Q.14   The bit rate of a digital communication system is  R  kbits/s. The modulation used is 32-QAM. The minimum bandwidth required for ISI free transmission is (A)  R  /10 Hz (B)  R  /10 kHz (C)  R  /5 Hz (D)  R  /5 kHz Q.15   Consider a delta connection of resistors and its equivalent star connection as shown below. If all elements of the delta connection are scaled by a factor k  , k  > 0, the elements of the corresponding star equivalent will be scaled by a factor of R B R C R b R a R c R A  (A) k  2  (B) k   (C) 1/  k   (D) k   Q.16   In the circuit shown below what is the output voltage (V out ) if a silicon transistor Q and an ideal op-amp are used? +15 V –15 V5V1 kΩ V out + –  Q  (A) 15 V (B) 0.7 V (C) 0.7 V (D) 15 V
We Need Your Support
Thank you for visiting our website and your interest in our free products and services. We are nonprofit website to share and download documents. To the running of this website, we need your help to support us.

Thanks to everyone for your continued support.

No, Thanks